Enhancements
- The Temperature data from an executed pressure test is now visible in the Pressure Test chart.
- Enables functionality to use Grip Length to determine Load Transfer Factor to be used during bolt Tensioning.
- Notes:
- Grip Length must be entered in mm.
- Users should always populate Grip Length for each flange where the tightening method is Tensioning.
- When Grip Length is not provided, the default Load Transfer Factor will be 1.1.
- It is advised that users perform a data audit to ensure no flanges have a 0 value on grip length. There are no warnings to the Mobile App or Control Center users when the grip length is 0 or when the Load Transfer Factor is defaulting to 1.1.
- Notes:
Additional Improvements:
- General bug fixes and performance improvements.